Anritsu MP1777A Spezifikationen PDF herunterladen (Seite 6)

DIGITAL LINK MEASURING INSTRUMENTS

134 For product ordering information, see pages 4 –10

Computer: IBM-PC/AT or full compatible, OS: Windows 95/98/NT, CPU: Pentium 166 MHz or higher,

Memory: 64 MB or more, Hard disk space: 100 MB or more

Required GPIB: National Instruments made GPIB interface (PCMCIA-GPIB or AT-GPIB/TNT series boards are recommended.)

system Display

Resolution: 800 x 600 or more, Display colors: 256 or more

∗If two or more applications are running simultaneously, operation cannot be guaranteed.

Measurement frequency: 2 to 12.5 GHz (eye diagram/eye margin measurement), 1 to 12.5 GHz (Q factor measurement)

Measurement patterns: PRGM, PRBS 7, 9, 11, 15, 20, 23, 31

Pattern format: Continuous/burst (To be synchronized within 1 s)

Eye margin measurement

Measurement resolution (threshold): 1 to 10 mV (1 mV steps), Measurement resolution (phase): 1 to 10 ps (1 ps steps),

Measurement rate: E-2 to E-15

Eye diagram measurement

Functions

Measurement resolution (phase): 1 to 10 ps (1 ps steps)

Measurement rate: E-2 to E-15 (actual measurement), E-3 to E-12 (estimate measurement)

Display rate: E-2 to E-15 (actual measurement), E-2 to E-4915 (estimate measurement)

Mask test judgment rate: E-2 to E-15

Q factor measurement

Measurement style: Multiple measurements at fixed phase/phase vs. Q factor measurements

Bit error rate range: Upper limit at E-3 to E-5, lower limit at E-7 to E-12

Minimum error count (measurement accuracy): 1, 10, 100, 1000

Vth shift width: Automatic, fixed (1 to 10 mV/1 mV/steps)

•

MX176400A Q and Eye Analysis Software

Number of outputs 2 (DATA/DATA independently)

Amplitude 0.25 to 2 Vp-p, 2 mV steps

: –2 to +2 V, 1 mV steps

Offset voltage

Display: V

, V

or V

selectable

Rise/fall time Typical 30 ps (10% to 90% of amplitude)

Data Pattern jitter ≤20 psp-p, typical 10 psp-p

output

Waveform distortion (0-peak) ≤15% or ≤150 mV whichever is greater

Gating input Provided

Load impedance 50 Ω (with back termination)

Connector APC-3.5

DATA/DATA tracking DATA amplitude and offset voltage can be set to the same values as for DATA.

Cross point adjustment function

The cross point of DATA and DATA outputs can be adjusted at semifixed resistor of side.

Number of outputs 3 (CLOCK 1/CLOCK 1, CLOCK 2)

Amplitude

CLOCK 1/CLOCK 1: 0.25 to 2 Vp-p (2 mV steps)

CLOCK 2: 1 Vp-p

Clock

CLOCK 1/CLOCK 1: V

–2 to +2 V (1 mV steps)

output

Offset voltage

CLOCK 2: V

0 V fixed

Rise/fall time Typical 30 ps (10% to 90% of amplitude)

Load impedance 50 Ω (CLOCK 1/CLOCK 1: with back termination)

Connector CLOCK 1/CLOCK 1: APC-3.5, CLOCK 2: SMA

Delay ±500 ps (1 ps steps)

Number of outputs: DATA 8, CLOCK 1

1/8 data and clock output Output level: ECL

Connector: SMA

Number of outputs DATA: 4, CLOCK: 1

Amplitude 0.5 to 2 Vp-p (2 mV steps)

Offset voltage V

: –1.5 to +1.5 V (1 mV steps)

Connector SMA

Sync. signal

Number of outputs 1 (1/64 clock, fixed position pattern, or variable position pattern selectable)

output

Output level 0/–1 V

Connector SMA

Media: 3.5 inch FD (2HD, 2DD)

Parameter memory Format: MS-DOS (Rev. 3.1)

∗

Content: Pattern or other parameters

Operating temperature range 0˚ to +50˚C

Dimensions and mass 426 (W) x 221 (H) x 450 (D) mm, ≤33 kg

Power ≤400 VA

EN61326: 1997/A1, 1998 (Class A)

EMC EN61000-3-2: 1995/A2, 1998 (Class A)

EN61326: 1997/A1, 1998 (Annex A)

LVD EN610101-1: 1993/A2, 1995 (Installation Category ΙΙ , Pollution degree 2)

1/4 data

and clock

output (op-

tion 03)

∗

∗1: When the Option 03 (1/4 speed output) is added, the 1/8 speed output is not available.

∗2: MS-DOS is a registered trademark of Microsoft Corporation.

1 2 3 4 5 6 7 8 9 10 11 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

Anritsu MP1777A Spezifikationen Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen Anritsu MP1777A