Anritsu ML2430A Bedienungsanleitung PDF herunterladen (Seite 202)

Remarks:

Stores the present configuration to the selected register.

Example:

To store the current instrument configuration in register 2:

ST2EN

Commands:

SV Save cal factor table

Syntax:

Remarks:

Since the ML2430A stores the cal factor tables in the sensors, this

command forces the edits to a cal factor table to be saved to the sensor.

The operation can take a couple of seconds to complete.

TR0 Trigger hold mode

Syntax:

TR0

Remarks:

Sets both channels to trigger hold mode. It does not trigger until it receives

a TR1 or TR2 or GET (group executive trigger), *TRG or TR3 command. If

it receives a TR3 command it reverts back to the trigger mode it was in be-

fore the TR0 command was sent. If the REM line is low, this command has

no effect.

Commands:

TR1, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2

TR1 Trigger immediate

Syntax:

TR1

Remarks:

Triggers a single reading which is added to the internal digital filter and the

updated filter power level is returned on the GPIB. After a TR1 command,

the instrument returns to TR0 standby mode.

Commands:

TR0, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2

TR2 Trigger with a settling delay

Syntax:

TR2

ML2430A OM 6-115

GPIB OPERATION HP 437B EMULATION COMMANDS

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 270 271

Keine Kommentare

Anritsu ML2430A Bedienungsanleitung Seite 202