Anritsu S113C Betriebsanweisung PDF herunterladen (Seite 41)

A yellow light may occur because the battery became too warm during the charge cycle.

The charger will allow the battery to cool off before continuing the charge. A yellow light

may also indicate that the charger is alternating charge to each of the two batteries.

A blinking red light indicates less than 13 VDC is being supplied to the charger stand.

Check that the correct AC charger adapter is connected to the charger stand. If the battery

fails to charge, contact your nearest Anritsu Service Center.

Determining Remaining Battery Life

When the AC-DC adapter is unplugged from the Site Master, the battery indicator symbol

will be continuously displayed at the top left corner of the Site Master display (Figure 2-9).

A totally black bar within the battery icon indicates a fully charged battery. When LOW

BATT replaces the battery indicator bar at the top left corner, a couple of minutes of mea

surement time remains. If a flashing LOW BATT is accompanied by an audio beep at the

end of each trace, the battery has approximately one minute of useable time remaining

Once all the power has drained from the battery, the Site Master display will fade. At this

point, your Site Master will switch itself off and the battery will need to be recharged.

2-25

Chapter 2 Functions and Operations

BATTERY INDI

Figure 2-9. Site Master Battery Indicator

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 119 120

Keine Kommentare

Anritsu S113C Betriebsanweisung Seite 41